43-121 - Expansion of existing manufacturing buildings
LAST AMENDED
5/29/2019


M1 M2 M3

In all districts, as indicated, where a #building or other structure# used for a conforming #manufacturing# #use# was in existence
prior to December 15, 1961, such #building or other structure# may be expanded for a #manufacturing# #use#. Such expansion
may consist of an #enlargement#, or additional #development#, on the same #zoning lot#, provided that:

(a)     the resulting total #floor area# shall not be greater than:

         (1)    150 percent of the #floor area# existing on December 15, 1961; or

         (2)    110 percent of the maximum #floor area# otherwise permitted under the provisions of Section 43-12 (Maximum
                 Floor Area Ratio).

  (b)     the resulting #floor area ratio# shall not exceed the highest of:

         (1)    150 percent of the maximum #floor area ratio# otherwise permitted under the provisions of Section 43-12;

         (2)     110 percent of the #floor area ratio# existing on December 15, 1961; or

         (3)    a #floor area ratio# of 2.4, provided that in the event this paragraph, (b)(3), is utilized, the City Planning
                 Commission shall administratively certify and the City Council approve, that such expansion will not adversely
                 affect the surrounding area.

Within M3-2 Districts in the portion of Queens Community District 2 located within a Subarea 2 Designated Area (as set forth
in APPENDIX J of this Resolution), the provisions of this Section shall also apply where a #building or other structure# on a
#zoning lot# larger than two acres used for a conforming #manufacturing# #use# was in existence prior to December 31, 1965.

The parking reduction provisions of Section 44-27 (Special Provisions for Expansion of Existing Manufacturing Buildings) shall
apply to such expansion.